[Mike Burrill]

Tony really good question.  Do you know what your squish gap is currently?  If you close it up too tight you run the risk of the piston contacting it.  I think there are a lot more variables then squish to effect RPM.  Are you racing on tracks with long straights or short?  How long are you at wide open throttle with the maximum RPM reached?

 

[Mike Burrill]

Still looking

[Mike Burrill]

Still looking  :(

[Mike Burrill]

Just out of curosity, what are you guys using to restrict the return line and what inlet needle do you use?  I have used this same set up on an ICC (w/o a restriction) and a Mikuni pump and I have also used a non return Dellorto pump (the one with the 1.5 PSI relief valve)  and both worked  OK for me.

[Mike Burrill]

I plan to go to Pitt Race.

[Mike Burrill]

Nope but I did  figure out a work around though.  Do you have some used ones?

[Mike Burrill]

Add Paul Nickle and Mike Burrill to the list of 100% er’s

[Mike Burrill]

Hello, still looking for blown up Pavesi or bits and pieces you may have.  Thanks!

[Mike Burrill]

Found one thanks to Stu!

[Mike Burrill]

I’m 1st in line with $$ in hand.  Crank up the production!!!!!

[Mike Burrill]

Hello Chris,

Thanks for your offer.  Just photos of the mechanics of how it works.  I am curious how you transfer power from the Starter motor to the crankshaft and how you disengage the drive.   I sent you an email about buying one and that is the route I would rather take so I hope in a couple months you have more for sale.  Never the less I am interested in how it works. so if you can send pics I would appreciate it.  Thanks, Mike Burrill

[Mike Burrill]

Jordon, Please check the private mail I sent you.  Thanks

[Mike Burrill]

Ted thanks for the offer. I am going from a 50mm set up to a 40mm set up so I can use a 40mm axle sprag  I recently bought.  If I come up empty on my search I could buy one of those 40>50MM bushings I guess.

[Mike Burrill]

Hi, still looking…..

[Mike Burrill]

Found one!  Thanks Dennis

[Mike Burrill]

Still looking for a crankcase…please

[Mike Burrill]

Hello Brian,  Wrong Mike,  he is Burrell.  I am Burrill.

[Mike Burrill]

Not sure if it is stock legal but you could send the cylinder out for replate.  I had Millennium Technologies fix a couple for me and they came out great.

[Mike Burrill]

Big thanks to MKC and the volunteers for another great MIS weekend!  My 3rd and the best one yet!

[Mike Burrill]

Will you take $60 for it shipped?

 

If yes…it’s sold!

[Author]

Posts