Forum Replies Created

Viewing 4 reply threads
  • Author
    Posts
    • March 26, 2014 at 5:54 pm #24559
      Stephen gleason
      Participant

      I’m at the point where I wanna work on timing curve anyone have any to suggest??

    • August 29, 2013 at 1:51 pm #8440
      Stephen gleason
      Participant

      Sent to your email

    • August 29, 2013 at 1:49 pm #8439
      Stephen gleason
      Participant

      Try again

       

       

      <span style=”background-color: rgba(255, 255, 255, 0);”>Pic

      Sent from my Verizon Wireless 4G LTE Smartphone

      </span>

    • August 29, 2013 at 1:45 pm #8438
      Stephen gleason
      Participant

      <span style=”background-color: rgba(255, 255, 255, 0);”>Pic

      Sent from my Verizon Wireless 4G LTE Smartphone

      </span>

    • August 29, 2013 at 11:22 am #8420
      Stephen gleason
      Participant

      <span style=”background-color: rgba(255, 255, 255, 0);”>Hello Ian

      I have had a chance to use a Dyno
      To test my cr250 based engine after getting a good baseline. I put carb (38mm mikuni )on flow bench got a baseline. Then taper bored and worked the bell area. To a 20% increase .
      Re installed on engine and. Reran  the pulls. And the graph layed right over the first runs
      So next I put a 44mm on just to see.  And it did same!!!
      Now I’m confused  (I have V force reeds).  Is that the limit of motor or is there a restriction I need to be looking for?   Any ideas
      Thanks in advance
      Stephen Gleason
      Sent from my iPad</span>

  • Author
    Posts
Viewing 4 reply threads