Forum Replies Created

Viewing 5 reply threads
  • Author
    Posts
    • September 22, 2015 at 9:19 pm #54607
      Brian Terpstra
      Participant

      Gary,  I do not have room to move the seat forward, I am 6’2″ and have a hard enough time already fitting.  How would I go about bending the right front down?

    • September 21, 2015 at 5:22 pm #54529
      Brian Terpstra
      Participant

      I have 5lb’s of lead mounted to the left side of the seat.  I was hoping there was an easier way than moving the seat.  What is the best way to move the struts that are welded to the frame?

    • May 25, 2015 at 7:09 am #48815
      Brian Terpstra
      Participant

      CRG

    • May 19, 2015 at 9:21 pm #48519
      Brian Terpstra
      Participant

      Alright, thanks guys.  I would think that when you purchase something like this it would fit without any trouble.

      I do always make sure the halves are the way they should be.  Then flip them, alternate them with even numbered sprockets, stand on my head and do the hokey pokey.😉

    • March 17, 2015 at 9:05 pm #44316
      Brian Terpstra
      Participant

      I am trying to link a video of the thing turning, not that computer savvy.

      if I were to install a spacer in the caliper, is that a specific part?  Do I make one with some washers?

    • March 16, 2015 at 5:55 pm #44218
      Brian Terpstra
      Participant

      I double checked to be sure, with the brake rod removed completely there is still a little drag.  How do I back the pads off?

  • Author
    Posts
Viewing 5 reply threads