Forum Replies Created

Viewing 6 reply threads
  • Author
    Posts
    • November 25, 2015 at 2:28 pm #57248
      Brad Richtsmeier
      Participant

      The kart has sold. Thanks for all the interest.

      The Mychron 4, ebox, GPS module, and data key did stay behind and are still for sale. I will post them in the parts section.

    • October 20, 2014 at 11:44 am #35614
      Brad Richtsmeier
      Participant

      Thanks for the advice so far, guys.

      For my last session, I did disconnect the vent tube attached to the gas tank to see if it was restrictive.  It did not seam to make a difference.  This tube was attached to small metal vent tube exiting the top of the tank.  The kart is a 2010 CRG Road Rebel if that matters.  Is it possible to get a larger size vent exiting the tank, or is that metal piece CRG standard  one size with the amount of tank venting being controlled by changing the plastic tube that attaches (the one I removed with no results)

    • October 18, 2014 at 12:11 pm #35504
      Brad Richtsmeier
      Participant

      I do wear a tight fitting race suit.  The first couple times I experienced it, I assumed that I was bumping the throttle cable.  I did take care to analyze it, and I’m definitely not.

      I should also mention, when the engine does this, the kart in general starts running differently.  The engine will bog down in places that it wasn’t a lap ago, and be kind of erratic with the power delivery.

      To me, it seams like the kart is running too rich, so maybe I should change the jetting to lean it out.  However, why does it run amazing during the opening laps of a stint most days?

    • August 30, 2014 at 11:32 am #32862
      Brad Richtsmeier
      Participant

      Thanks for the ideas.  All that helps me understand the internals and what needs to happen.

    • August 28, 2014 at 8:17 pm #32817
      Brad Richtsmeier
      Participant

      The bolt will not tighten with everything removed, so I believe the mount is the problem.  I don’t know a good way to remove it from inside the chassis tubing.  Any methods or advice would be welcome.

    • August 23, 2014 at 11:07 am #32492
      Brad Richtsmeier
      Participant

      I’m in Des Moines, Iowa.  I’ll give you a call today.  Thank you.

    • April 13, 2014 at 12:10 pm #25605
      Brad Richtsmeier
      Participant

      Thanks.   That appears to be pretty much what im looking for.

    • November 23, 2015 at 3:48 pm #57188
      Brad Richtsmeier
      Participant

      Will do. The kart is in Des Moines, IA.

    • February 12, 2014 at 7:23 am #21883
      Brad Richtsmeier
      Participant

      Kris,

      I just picked some wheels and tires up yesterday.  Thanks for being willing to helpl

      Brad

  • Author
    Posts
Viewing 6 reply threads