Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • in reply to: ROK GP #108723
    John Rawcliffe
    Participant

    Ray, do you guys do a rolling start or a standing start? My experience with the ROK GP has been terrible with a standing start. Once you get going it is a great engine and a lot of fun.

    in reply to: SOLD #99669
    John Rawcliffe
    Participant

    Do you still have these sprockets?

    in reply to: sold #25542
    John Rawcliffe
    Participant

    Glen,

    I assume these are used parts on the Leopard. When was the last time you ran them?

    John

    in reply to: leopard starts w/external, not w/ box #24102
    John Rawcliffe
    Participant

    I might add that with an led test light at the coil power lead I get a faint on/off signal during cranking with the battery. When I crank with the external starter I get a very strong on/off signal.

    in reply to: leopard starts w/external, not w/ box #24101
    John Rawcliffe
    Participant

    Jim, it’s my kart Ric is asking about. Are you talking about the center rotor that bolts to the crank? So when this goes bad does it burn up your powerpak or does it just not start until the rpm is higher as with an external starter?

     

    in reply to: Various TaG kart parts #17072
    John Rawcliffe
    Participant

    Chris,

    Could you quote me for the following:

    Thanks, John (jrrcliffe@yahoo.com)

    • Tie-rod ends (five)
    • Intrepid King Pin bolts (four)
    • IAME Leopard reed cage
    • IAME Leopard clutch keys and bearings
    • Tie Rods (eight)  (what size?)
    • Extra exhaust flex
    • Douglas Mag. rims with mounted MG slicks
Viewing 6 posts - 1 through 6 (of 6 total)