Dan Engberson

Forum Replies Created

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • January 29, 2016 at 11:28 am in reply to: Complete shifter package: $5500 #60165
    Dan Engberson
    Participant

    Sold

    January 21, 2016 at 8:19 am in reply to: Complete shifter package: $5500 #59741
    Dan Engberson
    Participant

    bump.

    Includes Mychron 4 and tons of extras: many gears, chains, short/med/long hubs, spare axle, extra wheels and tires, spare radiator, spare fuel tank, etc.

    November 24, 2015 at 3:53 pm in reply to: Hopping in one corner only, brand new chassis #57224
    Dan Engberson
    Participant

    Oh, and make sure your rear bumper is loose.

    November 24, 2015 at 3:53 pm in reply to: Hopping in one corner only, brand new chassis #57223
    Dan Engberson
    Participant

    I’d go to short hubs. You could also take out a seat strut (if you’re running two on each corner), but you could get to a setup where it’s nice and smooth, but slower. A little bit of hop can be good.

    June 1, 2015 at 12:34 pm in reply to: 2013 CRG roller $2000 #49175
    Dan Engberson
    Participant

    Engine is sold, so this is now being sold as a roller. Just $2000 for a great chassis!

    May 17, 2015 at 5:44 pm in reply to: SOLD #48364
    Dan Engberson
    Participant

    Sold

    May 5, 2015 at 8:13 am in reply to: SOLD #47601
    Dan Engberson
    Participant

    Yes. I had a buyer, but he’s having money issues and is backing out.

    I’ve had the engine totally rebuilt and put the Evo upgrade kit on it. It is available, but the price is higher since it’s all been completely redone (Evo kit installed, total overhaul both top and bottom end, new water pump shaft). I’m now looking for $3000. This is not only a savings of $500 over a brand-new motor, this motor has been tuned for better performance. It is absolutely race-ready!

    May 3, 2015 at 10:00 pm in reply to: moderators please delete thread #47523
    Dan Engberson
    Participant

    Also, I just had this chassis put on the frame jig so it’s perfectly straight.

    October 19, 2014 at 2:49 pm in reply to: SOLD #35573
    Dan Engberson
    Participant

    New price reflecting Evo kit installation and total rebuild.

    October 8, 2014 at 11:43 am in reply to: SOLD #35036
    Dan Engberson
    Participant

    It is a 2013 motor with a 2013 cylinder.

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)