It’s made by Iame. It’s a most likely a 100cc motor. They did make a 125cc and smaller ones for the kids as well. It was probably one of the first air cooled motors with an electric starter. Does that help?
This reply was modified 6 years, 11 months ago by Steven Novikoff.
I have a Birel with the same issue and have to purchase pads costing $70+ each. I tried other sintered pads but they last one run and actually burn up and separate from the backing plate. Don’t know about Tony karts, but assume it’s the same issue.
I followed the directions and uninstalled and reinstalled the software on my old laptop. I installed it on my new laptop. I sent you the required keycodes and request 6/8/15. I await your reply.
This the reason I am hesitant to uninstall it from my old laptop and them have to wait until they give me a the new key code to activate on the my new one.
I want to transfer my program to a new laptop and am very hesitant to remove it from my old one as your instructions say to do for fear of not being able to get hold of someone there. I understand about uninstalling it but wonder why you want us to reinstall it on the old computer and send that key code as well.
Well it was almost done at LAKC when they dropped all their Rotax classes for 2014 and then they were being disallowed in the Tag classes as well. LAKC then allowed the Rotax as well as the Iame X-30 to run with thier Tag classes. See http://www.lakc.org
I too have found myself not looking at EKN as much. I mostly like the forums and really missed not being able to pull all the new posts from my last visit like you could in the old forums. Seeing the last four or five posts is fine if you are looking at this constantly, but not if you only come back every few days or so.
