Hi Dillon

I can send them to you from the UK if required. They are £22.05 each and shipping would be about £30.00 for 4 That would make an axle set £118.20 (currently about $184 USD)

I’m sure you must be able to get them in the US, perhaps others will post up.

Best Regards

Ian :-)

Not sure on where you could get them in the US but the ones we tend to us are SKF Y Bearings with grub screws, 35mm ID, 72mm OD. They are all a standard size of 19mm to fit in the bearing carriers.

They only options is that you can have a choice of speed and load rating. By guessing I presume we use the highest with part number of YAR-207-2RF

http://www.skf.com/group/products/bearings-units-housings/ball-bearings/y-bearings/y-bearings-with-grub-screws/index.html

Seals, are another concern.  I got cheap ones in the US that had steel shields, that burned up pretty quick.  The best ones I ever had were whatever Russell installed from the factory on the Anderson.   They had nice rubber seals, and seemed to last forever.

I went with a complete 40mm setup on the Cobalt chassis, sooooo much easier to source everything….

CR