I know I’m late to the game on this post but for anyone else who looks at this down the road for reference:

Throw the PJ away! Or sell it on ebay. You will always have issues.

Get a PWM and start with (Sea level):

DGJ needle 2nd clip (never move clip its good at 2 forever)

M168 65-75 degrees

M165-162 80-100 degrees

Pilot 54-55

*These are baseline ref only

You can sometimes pick up a cheap PWM by searching for a mid 90s YZ250. I think they also came on a few other bikes stock. Also, a common mistake is to give too much gas when push starting. Don’t give it any until you hear bah dump dump and then only give it a little. And never ever pump, you will flood it every time.

Make sure your throttle adjustments are set so that without pushing the gas pedal there is just a crack of opening between the slide and barrel. Just the teeniest bit.

Sorry to sh** on the original question but I’ve messed with the PJs before and its just not tune-able esp with a kart pipe.