15hp 420cc powerfist remove governor how?

Viewing 1 reply thread
  • Author
    Posts
    • December 13, 2015 at 9:03 pm #58037
      FREDDY SANDOVAL
      Participant

      Liam

      Are you talking about the harbor freight predator engines?

      If so, then all you gotta do is remove tank, throttle linkage and lever, side engine cover (be careful not to break off the gasket)

      Remove the white plastic gear ( it will be a challenge removing the “C” clip retainer) bend the inside part of throttle linkage away from crank shaft, put everything back together, cut carburetor black plastic linkage holder ( you will need to order a new throttle linkage kit and throw away the original one.

      Anyhow, hope this helps, I’ll try to post a video, if you can’t get it to work.

    • December 14, 2015 at 10:49 am #58062
      Liam robinson
      Participant

      Check this thread too people are helping http://www.diygokarts.com/vb/showthread.php?t=31663

  • Author
    Posts
Viewing 1 reply thread
  • You must be logged in to reply to this topic.