Kill Switch Installation

Viewing 2 reply threads
  • Author
    Posts
    • July 6, 2014 at 10:11 am #29848
      Steen Carstensen
      Participant

      Moto or KZ ?  As far as I remember, there’s spare wire coming off the coil, you run a wire from that to a switch, and then from switch to ground. Get a push button switch that closes when pushed and open when released.

    • July 6, 2014 at 3:44 pm #29853
      Kyle Stevens
      Participant

      It’s a early 90s Rotax 128..and there is not an extra wire… So should I splice it into the ground wire so when I push the normally closed button it opens up and disconnects the ground? Or should it be done another way?

    • July 6, 2014 at 4:37 pm #29856
      Steen Carstensen
      Participant

      Which type of ignition is on that engine. Is it Selettra or PVL ?
      Go to their website, and you should be able to find the best way to wire up the kill switch. If you can’t find any info, contact Riley Will at BRC Engineering in Calgary Alberta, he knows more about those engines than anybody else.

  • Author
    Posts
Viewing 2 reply threads
  • You must be logged in to reply to this topic.