CR125 Help Needed-Loading Up

Viewing 1 reply thread
  • Author
    Posts
    • July 27, 2014 at 1:06 pm #30997
      Joey Kolbe
      Participant

      Hey Stanford – Are you using a pump around delivery system?

    • July 27, 2014 at 7:06 pm #31011
      jack lachut
      Participant

      have you checked the reeds?

      how is your air bleed screw set on the carb?

      • July 27, 2014 at 9:35 pm #31024
        Sanford Mitz
        Participant

        Thanks for the replies. The actual adventure on this engine took us through the usual, carbs, intake items, coils, stators, and even a second top end., etc. Finally in a start over mode, a pressure check of the case revealed that it was losing about 1#/minute. I split the case and replaced the center gasket. Also replaced the crank seals at the time. Post reseal, the pressure check dropped less than 1# in 30 minutes. Engine runs great now.

        PS-It had just been rebuilt.

  • Author
    Posts
Viewing 1 reply thread
  • You must be logged in to reply to this topic.