WF Break-in newbie questions

Juan Islas · Joined: 08 Dec 2009 Posts: 3

I just got my World Formula and was wondering if this oil is fine to perform the break in, is a Motul 3000 20W50
[/url]http://www.mandp.co.uk/productinfo/565253/Lubricants/4-Stroke-Oil/Motul/3000-20w50-4T[url]
Can't find any 30W or similar, only for cars

Not sure if I got it right about the break in procedure, first I need to run on the stand for 5-8min and then let it cool, do it a couple times 2 or 3, empty the oil and put new oil, then on the track run it for 15min at less than 6000RPM, do it 2 times, then again empty oil put new oil and is ready, I'm I correct? do I miss something? or is there a better way to perform the break in.

Any other suggestions about taking care of the engine would be gladly welcome.

Appreciate in advance your commments Smile

[/url]

Paul Hutt · Posted: Tue Mar 30, 2010 6:24 pm Post subject:

I suggest that you follow B&S break-in procedures. This can be found in your little manual.
_________________
Race Grandpa
Panic Motorsports West

John Matthews · Posted: Wed Mar 31, 2010 7:22 am Post subject:

I don't like running on the stand, any engine needs a load on it to seat the rings properly.

Drive it like ya stole it Laughing

Just don't try to do anything too fancy and check all your fasteners for the first few runs....
_________________
John Matthews
Heartbeat Power, LLC.

Paul Hutt · Posted: Wed Mar 31, 2010 4:42 pm Post subject: