John Matthews
Joined: 04 Dec 2004 Posts: 1990 Location: United States, Michigan, Williamsburg
|
Posted: Wed Sep 09, 2009 2:58 pm Post subject: |
|
|
Second problem first, you either need to set the float level, replace the inlet needle, or seat.
Then you can check out:
http://www.briggsracing.com/racing_engines/animal/animal_carb-tuning.pdf
That'll get you in the ballpark for your carb settings, once you get close (make sure you're not trying to run methanol jets with gas or vise/versa) you can ask more questions here or on Bob's 4 cycle.
Good luck, _________________ John Matthews
Heartbeat Power, LLC. |
|