 |
|
| View previous topic :: View next topic |
| Author |
Message |
Riley Will
Joined: 03 Sep 2001
Posts: 1361
Location: Canada, not USA state,
|
 Posted: Mon Sep 29, 2008 8:00 am Post subject: |
 |
|
Been there and done that!!!! Make it a 2 bearing with central brake disk. Also, make the engine mount rails 92mm.
It will handle better as a 2 bearing.....
_________________
Riley Will
BRC Engineering
rwill@brceng.com
(403) 216-0630 wk.
www.brceng.com |
|
| Back to top |
|
 |
james jackson
Joined: 02 Dec 2007
Posts: 305
|
| Posted: Mon Sep 29, 2008 1:07 pm Post subject: |
|
|
| Do you find it handles better when the rear is softer? Do you run on green tracks or grippe in tracks? |
|
| Back to top |
|
|
Riley Will
Joined: 03 Sep 2001
Posts: 1361
Location: Canada, not USA state,
|
| Posted: Mon Sep 29, 2008 1:14 pm Post subject: |
|
|
Kart fealt like a Rotax DD2, very planted in the back. Track was clean but green...Sticky tires....So yes, it is VERY planted (read too planted) in the back.....2 bearings was an improvement, next was softer axles and such.
I made custom mounts that matched each other left to right and the built offsets to finalize the engines locations. You can see them in the photo...The seat is a Tillet Large.
_________________
Riley Will
BRC Engineering
rwill@brceng.com
(403) 216-0630 wk.
www.brceng.com |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Go Top
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Login to check your private messages
Login
