| View previous topic :: View next topic |
| Author |
Message |
Dale Nickos
Joined: 18 Jul 2001
Posts: 303
Location: United States, State of Total Confusion, Oak Lawn, IL
|
 Posted: Tue Jul 24, 2001 7:25 pm Post subject: CR125 Carb Question... |
 |
|
Im getting ready to go to St. Louis. And I was wondering On a TM38mm Mikuni Carb...Which slot on the Pin should the clip be??? Im in the Middle and it seems to still dump too much fuel in...But I am told I should run it at least 1/2 way or more open...Due to the Full throttle racing.
Does it make a difference Sprint to Long track...
Thanks
DN  |
|
| Back to top |
|
 |
Rob Hogenmiller
Joined: 20 Jul 2001
Posts: 855
|
| Posted: Tue Jul 24, 2001 7:59 pm Post subject: CR125 Carb Question... |
|
|
Check out Eric Gorr Website It has lots of useful information on tuning a carbeurator.
Click 2cycle Technology then scroll down.
Carbs are generally tuned for the weather and yes also from a Sprint Track to a Road Track. YOu might be a little richer on a Road Course since you are at higher rpms for greater lengths. |
|
| Back to top |
|
|
Marc Miller
Advertiser
Joined: 18 Jul 2001
Posts: 1834
|
| Posted: Wed Jul 25, 2001 2:51 am Post subject: CR125 Carb Question... |
|
|
Dale-
Call T-Mac, Trevor McAlister... he uses the TMX Mikuni a lot and also has experience with this carb on his TM as well.
His number is 214-755-3477. He also runs some long track racing too, so he should know what setting you need to start with.
MM
ps- see ya at Gateway |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Login to check your private messages
Login
