05 cr125 intake

Andy Locuson · Posted: Sun Feb 24, 2013 7:15 am Post subject: 05 cr125 intake

Does anyone make a straight intake for a 05 cr125? I can only find the angled one

frank rapisarda · Posted: Sun Feb 24, 2013 3:12 pm Post subject:

Hey andy, i don't think anyone makes one for that year motor but they are not hard to make. I just mad one for mine, i run a mod moto. Are you going to be running in the N.E.S.S ?
_________________
new jersey

Andy Locuson · Posted: Sun Feb 24, 2013 4:50 pm Post subject:

No I have to try and get my kart out of the garge tho. It's been sitting for two years I want to try and get to Millville for practice this yesr but it's hard to go with no help

frank rapisarda · Posted: Sun Feb 24, 2013 5:19 pm Post subject:

andy is your motor all stock? does it still have the power valves in & hooked up?
_________________
new jersey

Andy Locuson · Posted: Sun Feb 24, 2013 5:34 pm Post subject:

This motor is actually a customers but the power valves are removed

frank rapisarda · Posted: Sun Feb 24, 2013 5:43 pm Post subject:

can they be put back in or did they get rid of all the parts for them?
_________________
new jersey

Andy Locuson · Posted: Sun Feb 24, 2013 6:07 pm Post subject:

They tossed the parts

frank rapisarda · Posted: Sun Feb 24, 2013 6:13 pm Post subject:

you said your motor is a customers, do you own a shop? I am an old MX guy, did motor work with some top national guys and know and of the jap shifter motor inside and out if you need to know anything or need any help with it.
_________________
new jersey

Andy Locuson · Posted: Sun Feb 24, 2013 6:33 pm Post subject:

I do motor stuff on the side I need a straight intake for a 05 lol

frank rapisarda · Posted: Sun Feb 24, 2013 7:14 pm Post subject:

have you seen the ones that guy's used to make back in 01 - 02 It's 1/2" aluminum plate and a bolt on carb boot, the boot cost about 20.00 part # m-vm-36-200 mikuni. the plate takes about 6hrs to make.
_________________
new jersey