| View previous topic :: View next topic |
| Author |
Message |
Todd Kageals
Joined: 15 Jun 2012
Posts: 271
|
 Posted: Sun Feb 03, 2013 7:07 am Post subject: CR125 water pump question |
 |
|
| Does anyone know if the updated water pump with the metal gear fits the 1994 CR 125? The one I am rebuilding on my spare motor has a questionable shaft (grooved). Fastech sells only 1 for the CR125 but they don't specify which years it will fit. |
|
| Back to top |
|
 |
Ray Lovestead
Joined: 21 Dec 2011
Posts: 156
Location: United States, Colorado, Louisville
|
| Posted: Tue Feb 05, 2013 2:08 pm Post subject: |
|
|
I don't know the answer to your question. But I DO know that you most definitely should not use that grooved shaft. I used one once, and it leaked water past the bearings and seals and got water into the bottom end and caused a big mess of things.
_________________
"Karting Expert Since 2014" |
|
| Back to top |
|
|
Sam Zavaglia
Joined: 23 Nov 2004
Posts: 1174
Location: Australia, Sydney,
|
|
| Back to top |
|
|
Chris Reinhardt
Joined: 29 Aug 2002
Posts: 2919
Location: United States, New York, Ossining
|
| Posted: Wed Feb 06, 2013 5:58 am Post subject: |
|
|
The early years 125 did come stock with the plastic gear, and when they shred all the teeth off, the plastic doesn't contaminate the oil!!! 
Yes, the later metal gear shaft should fit the earlier cases....
CR
_________________
East Coast Super Kart Series
"This is how we roll!"
www.eastcoastsuperkart.webs.com
CR2 Motorsports
"Home of Cobalt Superkarts"
www.CR2MotorSports.webs.com |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Login to check your private messages
Login
