Sam Marmurowicz
Joined: 01 Dec 2004
Posts: 27
|
 Posted: Sat May 05, 2012 4:46 pm Post subject: MyChron expert needed |
 |
|
Could a resident expert on mychron equipment give me a hand?
Got a M4 2T with a data hub and the new "expansion". I've got the dash unit hooked up to the Expansion. The dash then has the EGT sensor plugged into it, along with the IR Receiver.
My CHT sensor is plugged into the Expansion only because it has a four pin connector.
What I need to figure out is how I can make my CHT temp show on my dash instead of the EGT sensor? I gotta think that there's some way I can do this instead of finding a patch cable with three pins to hook it back up to the dash. |
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Login to check your private messages
Login
