cr80 mount

Scott Minehart · Joined: 22 Jul 2001 Posts: 67 Location: Raleigh, NC, USA

The mount I have for my CR80 is for a trackmagic. Would this same mount fit a Tony Mitox? Thanks

Scott

Tim Blaney · Joined: 18 Jul 2001 Posts: 1127

Scott,

You're best bet is to call JR at Power Source or a Tony dealer. They should be able to help. If it won't fix, the PSR mounts are excellent.

John Denman · Posted: Mon Jul 23, 2001 6:25 pm Post subject: cr80 mount

Maybe. I measured our Trackmagic to be 90mm center distance between the rails and the Tony (Extreme) to be 92mm give or take a mm, but no less than 2mm diference.

If it does clamp down on the wider rails, you may want a stop bolt to keep the mount from sliding back.

John Denman · Posted: Mon Jul 23, 2001 6:26 pm Post subject: cr80 mount

Maybe. I measured our Trackmagic to be 90mm center distance between the rails and the Tony (Extreme) to be 92mm give or take a mm, but no less than 2mm difference.

If it does clamp down on the wider rails, you may want a stop bolt to keep the mount from sliding back.

Scott Minehart · Joined: 22 Jul 2001 Posts: 67 Location: Raleigh, NC, USA

Thanks for the info. My Mitox comes in a little over a week from now. I will try to dig up some info. Whats a good place to get Tony parts? thanks

Scott

Larry Ferguson · Posted: Tue Jul 24, 2001 8:54 am Post subject: cr80 mount

I totally agree in regards to Power Source! Awesome product backed by an even better warrantee! Nothing better.
Larry